View and Download Dräger Polytron instructions for use manual online. approved as type P3U and P3FB. Transmitter for electrochemical Sensors. Dräger Polytron is able to detect over different gases. Specifically designed for the demanding requirements of a 24 hours a day, days a year sta-. The Dräger Polytron does not support the storage of calibration data in the .. The depicted page is part of the UL-certificate but refers to the Polytron
|Published (Last):||26 August 2009|
|PDF File Size:||14.37 Mb|
|ePub File Size:||16.4 Mb|
|Price:||Free* [*Free Regsitration Required]|
You can use the robust and long-life Page 47 Sensor-diagnosis function This function is active only if the Polytron is equipped with a sensor diag- nosis dongle Part No. Link will take you to our database for technical documentation where you 7000 find multilingual documents for download.
Page 17 Electrical connections — Ensure that the supply voltage provided by the control unit ignoring the load resistance is at least as high as specified in the tables of page 21 to page A duct mount kit enables the remote sensor to be mounted direct in elevated pipe work.
Electrical connections Transmitter without relay or pump module 2-wire: To view the Neuron ID: Up to three dongles may be installed simultaneously. Lifebuoys, brackets and lights.
Order information Technical specifications Documentation. Page 99 ATEX approval Page 33 Installing accessories 4 Plug the connection cable into the male connector behind the display, en- pooytron that the cable is not twisted. Fire hoses, spray nozzles and couplings. Designed for the industrial use, the Default password settings when the unit leaves the factory: Got it, continue to print.
Duct Adapter For Remote Sensor 4 Connect the plug of the Remote Cable cable length 5, 15 or 30 m to the remote sensor adapter and polyrton it by turning the ring clockwise.
Monitors foam and water. It is meeting the requirements of the compliance market as well as the high specification requirements of customized solutions.
No permission to request location. Connect shield to earth of central unit e.
Electrical connections Installing the transmitters in explosion-hazard areas of zone 2 without a safety barrier — Use drater supply units of the device category 3. Installing accessories 5 Slide the measuring unit with pump module into the docking station and lower it into position, see page The pump unit, like all accessories in the Polytron range is modular, and can be retrofitted into existing transmitters.
Gas detection equipment portable. You can configure up to 16 mmanual channels.
Sensor vitality This function is active only if the Polytron transmitter is equipped with the sensor diagnostic polyrton, see page Notes on handling the calibration gas and calibration accessories can be found in the section “Maintenance” on page With the Polytron remote sensor adaptor and lead it is possible to mount the sensor up to 30 metres from the polytron transmitter.
At regular intervals, to be defined by the person responsible for the gas warning installation: A data and event saving option is integrated into pllytron data dongle. Check the calibration, see page For use with the calibration bottle. Activating Info Mode Start-up The following icons may be displayed on the right side of the display in measuring mode in order to indicate the operating status of the unit: NOTE For operation with the relay module, the transmitter must have a 3-wire con- 700 to the control unit.
Installing the LON Communication on the transmitter — For installation using LON communication up to 63 Polytron can be connected to a four wire cable in any configuration including bus, star, loop and oolytron. The modular design allows for the subsequent retrofit onto any of the mentioned interfaces.