The Petzl Shunt multi-purpose device is designed for ascending as well as a backup brake for rappelling, The included instructions diagram well how to use . Tech Tip: Safe Handling of the Petzl Shunt Backup Device and that we strongly recommend that every technician receive personal instruction and refresher. Taking the advice, I have now got the Petzl Shunt but I am seeking some Assuming you’ve read the instructions, you’ll know that you can’t.
|Published (Last):||15 January 2008|
|PDF File Size:||2.46 Mb|
|ePub File Size:||9.92 Mb|
|Price:||Free* [*Free Regsitration Required]|
My setup is almost the same, except I have a handle ascender backup on the other rope instead of petzl shunt instructions knot backup below the shunt.
UKB Shark – on 19 Mar However, when loaded by body weight it seems to be very diffifuclt to decend under control.
Oceanrower – on 19 Mar If the shunt is loaded, I can put my belay plate on the other rope, then take the weight petzl shunt instructions to that rope in order to unload the shunt not normally difficult petzl shunt instructions the grades I climb – up to VS on this system. And if you havent read the incredibly important, safety critical instructions here they are.
Particularly relevant is section 8. You need to change to a descender fig 8, belay plate, gri gri, munter hitch, etc.
Please remember that an article is only an aid, and that we strongly recommend that every technician receive personal instruction and refresher training at regular intervals. If the string is tied petzl shunt instructions your hand, the Shunt could be instructipns down with you.
Assuming you’ve read the instructions, you’ll know that you can’t. Our testing here at Ropeworks has given us a strong preference for the Petzl Shunt. In reply to plogan5: Waymaking — Now Available to Pre-order. There are many backup devices on the market. This topic has been petzl shunt instructions, and won’t accept reply postings.
Petzl shunt instructions the same set up as me.
To descend just swap to the second strand and undo the overhands as you go. Petzl shunt instructions doubled and tied off at the top i. Easiest using 2 strands.
If you manage to release it, you can speed up very rapidly. Either remove the petzl shunt instructions for abseiling or just hold onto petzl shunt instructions prussik cord petzl shunt instrucctions release the shunt while abseiling back down.
As you fall, your hand could push the Shunt down the rope petzl shunt instructions above and keep it from working. Hello Just place your shunt on your leg-loop below your abseil device.
As with any item of life support equipment, technicians require training on the Shunt. With smaller cords 2mm tying a small overhand knot as shown above at the end of the tow string may petzl shunt instructions you keep control while still allowing shuny string to slip free of your hand. Easiest using 2 strands. It takes about peyzl seconds. I don’t petzl shunt instructions I’m using it with all the correct bits of kit.
The shunr reason I do this is during my baptism of fire of ‘how to use a shunt’ I discovered it petzl shunt instructions sometimes difficult to reach the ab line this was due to the nature of the route I was on so I quickly learnt to have the ab line rope clipped to me and then I petzl shunt instructions If I already have it in the GriGri then when I’m resting I can pull the slack through the Grigri and essentially back the shunt up.
Can you help me understand how to use it properly please? Trango cich is worth a mention here, it can be attached to a loaded rope so you just clip it on above your ascender and connect it your harness via a screwgate quickdraw then you can take the weight on the cinch and remove the ascender.
Cheese Monkey – on 20 Mar petzl shunt instructions We tested the maximum impact force on variety of ropes, and compared the Shunt against several other devices.
In order to catch the extra mass of a two-person shock load the Shunt must be kept nearly as high as its lanyard will allow at all times during the rescue. New Topic Reply to Petzl shunt instructions.
I tie overhands in the second strand and clip a quickdraw into them as I go. My set up when using my shunt: Hi, Thanks to everyone for your helpful comments on the previous query I posted recently; http: To be honest I usually just take the shunt off and of course the ascender to abseil down.
The Shunt performs differently with different petzl shunt instructions.
By controlling the Friction Round your foot you can move up and down the rope using just the Shunt. Takes a bit of Practice.
Choss on 20 Mar SGD – on 20 Mar instrutcions Can you help me understand petzl shunt instructions to use it properly please? One strand on the shunt, the petzl shunt instructions strand left free to abseil back petzl shunt instructions. Trango cich is worth a mention here, it can be attached petzl shunt instructions a loaded rope so you just clip it on above your ascender and connect it your harness via a screwgate quickdraw then instructiosn can take the weight on the cinch and remove the ascender.
By controlling the Friction Round your foot you can sshunt up and down the rope petzl shunt instructions just the Shunt. Safe Handling of the Petzl Shunt Backup Device instructiosn that we strongly recommend that every technician receive personal instruction and refresher.